How to do the maintenance and maintenance of the engraving machine?
1. Spindle motor: the speed should be controlled within an appropriate range
1. Too fast will affect the life of the motor.
2. High speed for a long time will increase the noise of the motor.
3. The spindle motor is an air-cooled motor and does not need to add any coolant.
2. All parts of the engraving machine do not need to be adjusted so as not to affect the operation and accuracy of the machine.
3. Control and typesetting The computer needs to be regularly anti-virus and disk scanning to check whether the hard disk has bad areas.
Fourth, the plastic shell of the engraving machine cannot be wiped with organic solvents, please wipe it with a soft cloth and detergent.
5. Do not block the two DC fans and spindle air vents in the engraving machine control cabinet to ensure good heat dissipation.
6. Regularly check, clean the screw, add or replace lubricating oil (WD-40 anti-rust oil), keep the screw, nut and other moving parts in a good lubricating state and reduce the degree of mechanical wear.
7. The engraving machine should be grounded to prevent interference caused by static electricity.