The use of a glass edging machine requires regular inspection and maintenance so that the machine can complete the work better and more professionally. However, some people may not know how to inspect and maintain the glass edging machine. Let's learn together.
1. Check the water flow to make sure the nozzle is normal
Open the low-pressure water flow to observe, the water flow should be symmetrical, and its width depends on the type of nozzle used. Some nozzles of the arc edging machine have a slightly wider water flow, while others have a narrower water flow, but will be very continuous. If the water flow conditions are not correct, it means that the nozzle has been damaged and should be replaced immediately to prevent the damaged nozzle from causing internal damage to the cutting head of the glass edging machine.
2. Regularly check the cutting head and keep it from wear
The cutting head is an important part of the glass edging machine, and it is relatively easy to wear or damage. Therefore, glass processing equipment should regularly check the cutting head for wear or signs of damage.
3. Check the system and keep it in good working condition
Regularly inspect and replace the consumable parts of the glass frosted conveying system, such as pipes and joints. CNC front and rear knives ensure that any part of the sand conveying system below the bottom of the micro hopper will not be exposed to the air. During the inspection, the sand transport was disconnected from the base of the mini hopper, the jet was manually opened, and the thumb was attached to the end of the sand transport line. If there is enough vacuum, the tip of the thumb may be suppressed, otherwise, there is no vacuum, which means that the cutting head entrance of the glass grinder is blocked or there are cracks on the conveyor line. It is necessary to fully utilize the system efficiency and extend the use of the glass grinder The question of longevity.
Through the above three points, we can know that when using a glass edging machine, we should regularly inspect and maintain the nozzle, cutting head, and system. The staff should clean up the equipment every day after use, and conduct a comprehensive inspection once a week to solve the problems found in time to ensure that the glass edging machine completes the work with quality and quantity.