The use of any machine requires regular inspection and maintenance, and the use of glass edging machines also requires inspection and maintenance, in order to make professional glass edging machines better and professionally complete the work, but for glass edging machines, How to check and how to maintain it may not be clear to everyone, so now we come to understand how to check and maintain the glass edging machine?
1. Check the normality of the nozzle by checking the water flow: open the water flow under low pressure for observation, the water flow should be symmetrical, and its width depends on the type of nozzle used. Arc edging machine Some nozzles have a slightly wider water flow, and some nozzles have a narrower water flow but will be very continuous. If the water flow is not correct, it means that the nozzle has been damaged, and it should be replaced immediately to avoid damage to the cutting head of the glass edger.
2. Regularly check the cutting head and keep it free of wear: The cutting head is an important part of the glass edging machine and is relatively easy to wear or damage. Therefore, the ceramic processing equipment should be regularly checked for the wear status or signs of damage. For example, accidental contact of the mixing tube with the fixture will damage the nozzle nut and internal parts that keep the mixing tube aligned.
3. Check the system and keep it in good working condition: regularly check and replace the consumable parts of the sand conveying system of the glass edging machine, such as pipes and joints. CNC front and rear cutters Ensure that no parts of the sand conveying system below the bottom of the micro hopper are exposed to air. When performing this check, disconnect the sand conveying pipeline from the joint at the bottom of the micro hopper, manually open the jet and stick your thumb to one end of the sand conveying pipeline. If there is sufficient vacuum, the tip of the thumb may be dented, and vice versa. It means that the vacuum is not in the middle, which means that the cutting head entrance of the glass edging machine is blocked or there is a crack in the sand conveying pipeline, which must be solved to give full play to the efficiency of the system and extend the service life of the glass edging machine.
Through the above three points, you can understand that the use of glass edging machine should regularly check and maintain the nozzle, cutting head and system. The staff is good to clean up the equipment every day after the end of use, and perform a comprehensive weekly In order to ensure the quality and quantity of the glass edging machine, the quality and quantity of the glass edging machine can be completed in time.